9L Waste Oil Fluid Extractor Pump Manual Suction Vacuum Fuel Car Boat Transfer

Specifications:

Instructions

1.Ensure the vehicle is on level ground and run the engine for approximately 5 minutes to warm the oil and allow any contaminants within the oil to thoroughly mix and turn the engine off.

2.Remove the vehicle's oil dipstick.

3.Connect the main suction tube to both the pump inlet and probe.

4.Raise the handle to its highest limit and pump it fully several time to create a vacuum which will automatically begin to extract the oil/fluid.

5.Once completed, remove the main suction tube from the pump, pour the oil/fluid into a suitable container and dispose of it in accordance with local authority regulations.

6.In the event of fluid entering the inner pump chamber it can be expelled from the unit as follows.

Package

1x Oil Fluid Extractor

(With 4 Suction Tube and 1 Copper Tube)

Warning

Don't use gasoline in this item;

To be on the safe side, Do not use this tool to extract or save the dangerous chemicals, poisons, corrosive liquid, alkaline liquid and solvent. Don't use this tool to extract, absorb or save petroleum or other flammable liquids. unfair processing tools such as don't throw away do not dismount tool, modified, or transform in any purpose, is limited to this function. Don't put the products and pipe in high temperature, snow and rain, direct sunlight place and so on. must drain fluid and clean after each use .