




Uses For 4 Way Speaker Cable Selector Switch
This switch allows four pairs of speakers to be run from an amplifier with only one set of outputs, or four pairs of speakers from the one speaker cable. The switch allows you to listen to one pair, two pairs, three pairs, or all four pairs at once! The spring clip terminals accept speaker cable up to 16 AWG.
Impedance: Prevent Damage to your Amp!
Please note that this switch can only be used with an amplifier that can operate down to 4 Ohms. If you are not sure if your amp is compatible, get in touch with us.
Impedance switching built into the unit ensures the minimum impedance seen by the amp is 4 Ohm (if using 8 Ohm speakers), no matter how many of the pairs of speakers are switched on. See chart below.
Impedance Chart
Switches on (impedance):
- 1/2/3/4 (8 Ohm)
- 1+2 (16 Ohm)
- 1+3 (4 Ohm)
- 1+4 (4 Ohm)
- 2+3 (4 Ohm)
- 2+4 (4 Ohm)
- 3+4 (16 Ohm)
- 1+2+3 (5.3 Ohm)
- 1+2+4 (5.3 Ohm)
- 1+3+4 (5.3 Ohm)
- 2+3+4 (5.3 Ohm)
- 1+2+3+4 (8 Ohm)
Orders are typically dispatched from our Hallam warehouse (Melbourne, Victoria) within 24 to 48 hours of payment being received, via Australia Post.
Delivery times vary by location, but estimated timeframes are between 2 - 8 business days.
Some items cannot be delivered to PO Box addresses or Parcel Lockers.
Orders which are especially large or heavy must be shipped via courier and will require an address where there is someone available during the day to receive and sign for the items.
Estimated Delivery Time Frame: 2-8 business days