12 Pin Replacement Cartridges for M8S PowerDerm 10X

Discover the ideal companion for your M8S pen - a specialized cartridge designed to address your skin concerns and conditions. The 12-Pin Microneedle Cartridge is tailored to effectively minimize the appearance of wrinkles and fine lines.

By utilizing the 12-Pin Microneedle Cartridge, you can anticipate the following benefits:

1. Diminished deep wrinkles and fine lines
2. Enhanced skin texture
3. Firmer, more resilient skin
4. Reduced visibility of acne scars
5. Minimized hyperpigmentation
6. Assistance with sun damage
7. Promotion of even skin tone

The upgraded features of the cartridge are specifically tailored to complement the new Dr. Pen M8S Microneedling Pen:

1. The newly integrated wavy contact edge facilitates improved absorption of skincare products.
2. The recently incorporated three snap connector enhances the performance and protection of the device.
3. Seamless compatibility with the Dr. Pen M8S Microneedling Pen.
4. Constructed with high-quality stainless steel for optimal durability.
5. Maximum penetration depth of 2.5mm.

What's Included

• 10x pack of 12-pin Microneedle Cartridges for Dr. Pen M8S Microneedling Pen

DO NOT USE

• One cartridge more than once for safety and hygiene reasons
• On open wounds
• On broken skin
• On active acne
• Or continue to use if irritation occurs

Important:

To guarantee the safety and hygiene of the microneedling treatment, it is crucial to sterilize the microneedling cartridges before each use. It is important to adhere to the following steps diligently to ensure proper sterilization. Here is a guide on how to sterilize microneedling cartridges:

1. First, ensure that you have all the necessary equipment for sterilisation; gloves, isopropyl alcohol solution (70% or above) and a clean container to hold the solution.
2. Put on your gloves to avoid contaminating the cartridges during the sterilisation process.
3. Check on your cartridge; ensure the needles are in perfect condition (i.e. not bending) and remove any debris.
4. Pour enough alcohol solution into the container and dip the cartridge needle into a sterilisation container, then soak for a couple of minutes.
5. If you have alcohol solution in a spray model, you can spray it towards the needle head of the cartridge.
6. Once the sterilisation is complete, allow the cartridge to air dry before using it.
7. Finally, your cartridge is ready for use.

How to Use

1. Remove the sterile cover on the top of the cartridge
2. After that, connect the cartridge to the Dr. Pen M8S Microneedling Pen
3. After double-cleansing the face, put Femvy Hyaluronic Acid serum in the desired small areas for treatment
4. Turn the pen on, and set the gauge's depth and pen's speed according to your preferred specific treatment
5. Slowly start the treatment in small areas
6. The recommended pattern to use is cross-hatch and use only light pressure to ensure not to drag/pull the skin.
7. Safely dispose of your microneedling cartridge after one treatment

Usage

Schedule your microneedling treatment once every 4-6 weeks

Disclaimer

Please speak with your doctor before purchasing any Dr Pen products. The content on this site is not intended to substitute for the advice of a qualified physician, pharmacist, or other licensed healthcare professional. The products may have additional information and instructions on or inside the packaging that you should carefully read and follow. Contact your healthcare provider immediately if you suspect that you have a medical problem. This product may not have been evaluated by the Food and Drug Administration and is not intended to diagnose, treat, cure, or prevent any disease or health condition. For any concerns or questions, please contact your GP or dermatologist.