Victron MultiPlus Inverter Charger 12/1200/50-16
The Multi 500VA is a powerful true sine wave inverter, a sophisticated battery charger that features adaptive charge technology and a high-speed AC transfer switch in a single compact enclosure.
Specifications:
| Output Current Rating (Amps) |
50.0 Amps |
| Wattage |
1000W |
| Peak Power |
2400W |
| Output Voltage and Frequency |
230 Vac ± 2% / 50 Hz ± 0.1% |
| Output Power |
1000W (continuous output power at 25°C) | 900W (continuous output power at 40°C) | 600W (continuous output power at 65°C) |
| Input Voltage |
9.5-17V |
| Operating Temperature Range |
-40 to +65°C |
| AC Input |
187-265VAC | 45-65Hz |
| Inverter Output Continuous Watts |
1000W (continuous output power at 25°C) |
| Charge voltage 'absorption' |
14.4V |
| Charge Voltage Float - Wet (25 degrees)** |
13.8V |
| Charge voltage 'storage' |
13.2 |
| Inverter Output Nominal Efficiency |
93% (maximum) |
| No load power consumption |
10W | 2W in search mode |
| Product Dimensions (mm) LxWxH |
250 x 100 x 406 |
| Net Weight (kg) |
8.2 Kg |
Features:
Proven reliability
The full bridge plus toroidal transformer topology has proven its reliability over many years. The inverter is short circuit proof and protected against overheating, whether due to overload or high ambient temperature.
PowerControl
Dealing with limited generator, shore side or grid power (800VA model only) With the Multi Control Panel a maximum generator or shore current can be set. The MultiPlus will then take account of other AC loads and use whatever is extra for charging, thus preventing the generator or shore supply from being overloaded.
High start-up power
Needed to start high inrush loads such as power converters for LED lamps, halogen lamps or electric tools.
Search Mode
When Search Mode is ‘on’, the power consumption of the inverter in no-load operation is decreased by approx. 70%. In this mode the Multi, when operating in inverter mode, is switched off in case of no load or very low load, and switches on every two seconds for a short period. If the output current exceeds a set level, the inverter will continue to operate. If not, the inverter will shut down again.
Programmable relay
By default, the programmable relay is set as an alarm relay, i.e. the relay will de-energise in the event of an alarm or a pre-alarm (inverter almost too hot, ripple on the input almost too high, battery voltage almost too low).
Remote on / off / charger on
Remote operation can be implemented by connecting a switch to the three pole connector.
