Truma AquaGo Comfort Kit - White

The all new Aquago Comfort is leading the field in instantaneous hot water systems when on the run. For the casual or permanent recreational vehicle owner the new generation of Truma water heaters is in a class of its own. R.V.'s fitted with the class leading Truma Aqua Go, make their touring hassle free whilst on the road due to having the controls to set a precise water temperature and deliver limitless amouts of hot water. The Truma Aquago Comfort will deliver an instantaneous continuous hot water flow in just six seconds ideally suited for any recreational vehicle. The Aquago Comfort has been pushed to its limits in trails and testing and features a step-less burner management system with a powerful microprocessor allowing the heat to rise and keep a holding temperature of 49ºc. The Truma Aquago Comfort was designed with safety in mind and has an extensive list of features including a low voltage sensor, over temperature shut down, flame monitoring device, and a water thermal and exhaust gas ova temperature cut off. 

FEATURES: 

• Instant & Continuous water heater, utilising hybrid technology with patented pending temperature stabilizer - 6 Second warm up
• Electronic control delivers constant water temperatures up to 49 degrees
• Semi-Automated decalcification - LED display indicates when service is required
• Tools free draining with the 'Easy Drain Lever' means hassle free maintenance
• Reusable filter cartridge to reduce scale sediment
• Common size cut-out allowing easy slide-in upgrade (Same size as Suburban)
• 2 years warranty
• Available in white or black door finish
• Nominal Gas Consumption: 61.9 Mj/h

SPECIFICATIONS:

• Fuel: LP Gas (Propane only)
• Dimensions: 318 x 318 x 394mm
• Heating Rate: Continuous output 49 degrees Celsius
• WaterMark Certified: Yes
• Power: 12V DC; <2.5A
• Nominal input rate: 5.9 - 17.6kw
• Gas inlet pressure: 2.75 Kpa
• Water volume in stabiliser: 1.3L
• Weight: 15.5kg
• Water Operating Pressure: 65 psi (4.5 bar) max

Note: This product is a gas appliance that must be installed by a qualified and licenced gas fitter to the current Australian Standard. Failure to do so will void the warranty and may pose a health and safety risk.

Truma AquaGo Series - What is the Difference?

How it works

The Truma Aqua Go Plus was built exclusively for the recreational vehicle owner. The Aqua Go Plus runs on propane gas only. The Truma Aqua Go is connected between the hot water plumbing system and the R. V’s fresh water supply. The external ventilation on the exterior door allows any combustion air to feed into the system and exhaust to exit freely. When the system is turned on, the water will be warmed instantly.

• The Aqua Go was designed with safety in mind, when the appliance reaches 0.4gallons/min (1.5 litre/min) and the faucet is closed, and the automated burner switches off.
• The appliance is fitted with a volume flow sensor and will detect the hot water faucet being opened and when the volume flow is higher than 0.4gallons/min (1.5 litre/min) then the automated burner will start.
• The heater output is continuously adjusted through the burner control and based on volume flow and inlet water temperature, so approximately the temperature at the hot water outlet is 120˚F (49˚c). The Aqua Go Plus is also fitted with a temperature stabilizer to decrease fluctuations of the outlet temperature.
• After a period of time when the maximum temperature is reached at the faucet or the shower, the period will differ from model (Aqua Go Comfort to the Aqua Go Plus) and changes in the water plumbing (insulation, Variances in pipe length, circulation line, etc.) exactly like a house hold shower a desired temperature is reached by adding cold  water.   

​Not what your looking for? Feel free to browse the rest of our range of Truma Appliances, Truma Hot Water Systems & Hot Water Systems - For any further infomation or to speak our Hot Water Systems experts dial -1800 RV PARTS