DMA Diff Breather Kit 4 Port Mitsubishi Triton Mr 4x4 Off Road
The following components are supplied with this universal kit
Where a warranty fault has been recognized and accepted by Diesel Manager Australia (DMA) a warranty replacement will be issued to the buyer.
Replacement Products will be provided were.
An incorrect item has been supplied.
The item has a manufacturer fault & has been recognized by Diesel Manager Australia (DMA)
Replacement will only be provided upon receipt & inspection of said product & are deemed faulty or incorrectly supplied.
Exchanges will only be provided on products that are unused & in a saleable condition. Please note must be in original & undamaged packaging, not had been installed into a vehicle of any kind. Note Electrical components of any kind will not be accepted if the packing seal or sealed plastic bag has been opened or tampered with in any way or product has been fitted / installed.
In the event you receive an incorrect or faulty product please send us a message & we will respond as quickly as possible with resolution for you.
Exclusion
The warranty does not cover Damage (Breakage) caused by misuse, or improper installation or negligence by the vehicle owner to Check & Maintain the installed Product or Kit, liability for labor charges or consequential loss or damage of any kind incurred as a result of the failure of a Diesel Manager Australia (DMA) Product / item.
Any expenses relating to installation and / or removal of the said product, diagnosis, or testing.
Any defect or failure due to accident, misuse, abuse, and relocation to another vehicle, negligence, non-observance to any fitting instructions supplied with the product.
Product or Kits being used for Alternate use other than what the Product or Kit was Designed or Advertised for within any Online Sales Platform not excluding Trade or retails sales.
Warranty is not transferable, stays with the original purchaser and cannot transfer to another owner.
INSTALLATION TIPS-Due to difficulty in locating Gearbox & Transfer case Breather positions on all vehicles this kit is to be installed by a qualified mechanic / workshop that has a hoist with safety equipment available.
Some Transfer Cases, Gearbox’s & diff housings will not have a Threaded fitting for removal, they will have a Pressed-In Top cover / Hat breather vent installed, in these cases a mechanic must install this kit as they will need to modify the pressed in Top cover / Hat breather to allow rubber hose to be connected and then allowing connection to your diff breather kits hose / fittings / Brass Hose Barbs.
PLEASE NOTE: ADDITIONAL COMPONENTS MAY BE REQUIRED TO INSTALL THIS KIT DEPENDING UPON YOUR VEHICLE APPLICATION & SERIES.
PLEASE NOTE: DIESEL MANAGER AUSTRALIA (DMA) DIFF BREATHER KITS ARE TO BE INSTALLED BY LICENSED WORKSHOP THAT HAS ACCESS TO A HOIST WITH SAFETY EQUIPMENT AVAILABLE.
IMPORTANT NOTE: IT IS THE VEHICLE OWNERS’ RESPONSIBILITY TO CHECK & MAINTAIN THIS KIT AFTER INSTALLATION, EXAMPLE 1-Check all hoses are always securely installed within the fittings in Diffs, Transfer Case, Gear Box or Transmission (ALL BREATHER POINTS) & Bulkhead Breather-Filter fitting within the Mounting Bracket. 2-Check Breather-Filters have not been DAMAGED at all as this will allow Dust, Water & other unwanted contaminates to enter.
IMPORTANT: The warranty does not cover Damage (Breakage) caused by misuse, or improper installation or negligence by the vehicle owner to Check & and; Maintain the installed kit, liability for labor charges or consequential loss or damage of any kind incurred as a result of the failure of a Diesel Manager (DMA) Product / item. IF YOU HAVE A SNORKEL INSTALLED WITH INTENTIONS OF TRAVELING THROUGH WATER CROSSING WHERE THE WATER LEVEL WILL BE OVER THE FRONT BONNET / ENGINE BAY- YOU WILL NEED TO MOUNT THE BRACKET / BREATHER MANIFOLD AT A HIGHER POSITION.
Copyright 2024 MyDeal.com.au - © All rights reserved
