DIFF BREATHER KIT 2PORT SUZUKI JIMNY Universal System DMA 4X4 OFF ROAD DB911B

DIFF BREATHER KIT 2PORT SUZUKI JIMNY Universal System DMA 4X4 OFF ROAD DB911B

 

       THE FOLLOWING COMPONENTS ARE SUPPLIED WITH THIS UNIVERSAL KIT

  • 1 X STAINLESS STEEL MOUNTING BRACKET WITH LABEL ATTACHED, TO BE MOUNTED WITHIN THE ENGINE BAY THAT WILL BE ALWAYS ABOVE THE WATER LEVEL.
  • 2 X GALVANIZED SELF TAPPING SCREWS FOR MOUNTING THE BRACKET.
  • 2 X O-RING SEALED BULKHEAD FITTINGS.
  • 2 X BREATHER / FILTERS
  • 2 X O-RING SEALED WATER-RESISTANT PUSH FITTINGS.
  • 2 X BRASS HOSE BARBS / Male - For easy connection to existing Factory Breather Hose / Lines if required.
  • 15 x CABLE TIES, UV RESISTANT.
  • 10 X METERS 6MM-OD HOSE.
  • 2 X CORRUGATED PROTECTIVE SLEEVES TO ENCLOSE BREATHER HOSE AT CABLE TIE POINTS IF NEEDED.
  • 1 X INSTALLATION INSTRUCTIONS.
  • 5 YEAR REPLACEMENT WARRANTY.
  • INSTALLATION TIPS-Due to difficulty in locating Gearbox & Transfer case Breather positions on all vehicles this kit is to be installed by a qualified mechanic / workshop that has a hoist with safety equipment available.
  • Some Transfer Cases, Gearbox’s & diff housings will not have a Threaded fitting for removal, they will have a Pressed-In Top cover / Hat breather vent installed, in these cases a mechanic must install this kit as they will need to modify the pressed in Top cover / Hat breather to allow rubber hose to be connected and then allowing connection to your diff breather kits hose / fittings / Brass Hose Barbs.
  • PLEASE NOTE: ADDITIONAL COMPONENTS MAY BE REQUIRED TO INSTALL THIS KIT DEPENDING UPON YOUR VEHICLE APPLICATION & SERIES.

PLEASE NOTE: DIESEL MANAGER (DMA) DIFF BREATHER KITS ARE TO BE INSTALLED BY LICENCED WORKSHOP THAT HAS ACCESS TO A HOIST WITH SAFETY EQUIPMENT AVAILABLE.

  • IMPORTANT NOTE: IT IS THE VEHICLE OWNERS’ RESPONSIBILITY TO CHECK & MAINTAIN THIS KIT AFTER INSTALLATION, EXAMPLE 1-Check all hoses are always securely installed within the fittings in Diffs, Transfer Case, Gear Box or Transmission (ALL BREATHER POINTS) & Bulkhead Breather-Filter fitting within the Mounting Bracket. 2-Check Breather-Filters have not been DAMAGED at all as this will allow Dust, Water & other unwanted contaminates to enter. The warranty does not cover Damage caused by misuse or improper installation or negligence by the vehicle owner to Check & Maintain the installed kit, liability for labour charges or consequential loss or damage of any kind incurred as a result of the failure of a Diesel Manager (DMA) Product / item. READ WARRANTY EXCLUSIONS within the Warranty section of this store.

 

 

 

SKU: DB911B

Shipping Details

Please note we do not ship to Po Boxes, Parcel Locker / Suites or Parcel exchange, a physical delivery address must be supplied.

A Physical Address is a real street address that you can use for business or personal use.

Where a warranty fault has been recognized and accepted by Diesel Manager Australia (DMA) a warranty replacement will be issued to the buyer.

Replacement Products will be provided were.

An incorrect item has been supplied.
The item has a manufacturer fault & has been recognized by Diesel Manager Australia (DMA)
Replacement will only be provided upon receipt & inspection of said product & are deemed faulty or incorrectly supplied.

Exchanges will only be provided on products that are unused & in a saleable condition. Please note must be in original & undamaged packaging, not had been installed into a vehicle of any kind. Note Electrical components of any kind will not be accepted if the packing seal or sealed plastic bag has been opened or tampered with in any way or product has been fitted / installed.

In the event you receive an incorrect or faulty product please send us a message & we will respond as quickly as possible with resolution for you.

Exclusion

The warranty does not cover Damage (Breakage) caused by misuse, or improper installation or negligence by the vehicle owner to Check & Maintain the installed Product or Kit, liability for labor charges or consequential loss or damage of any kind incurred as a result of the failure of a Diesel Manager Australia (DMA) Product / item.
Any expenses relating to installation and / or removal of the said product, diagnosis, or testing.
Any defect or failure due to accident, misuse, abuse, and relocation to another vehicle, negligence, non-observance to any fitting instructions supplied with the product.
Product or Kits being used for Alternate use other than what the Product or Kit was Designed or Advertised for within any Online Sales Platform not excluding Trade or retails sales.
Warranty is not transferable, stays with the original purchaser and cannot transfer to another owner.

INSTALLATION TIPS-Due to difficulty in locating Gearbox & Transfer case Breather positions on all vehicles this kit is to be installed by a qualified mechanic / workshop that has a hoist with safety equipment available.
Some Transfer Cases, Gearbox’s & diff housings will not have a Threaded fitting for removal, they will have a Pressed-In Top cover / Hat breather vent installed, in these cases a mechanic must install this kit as they will need to modify the pressed in Top cover / Hat breather to allow rubber hose to be connected and then allowing connection to your diff breather kits hose / fittings / Brass Hose Barbs.
PLEASE NOTE: ADDITIONAL COMPONENTS MAY BE REQUIRED TO INSTALL THIS KIT DEPENDING UPON YOUR VEHICLE APPLICATION & SERIES.
PLEASE NOTE: DIESEL MANAGER AUSTRALIA (DMA) DIFF BREATHER KITS ARE TO BE INSTALLED BY LICENSED WORKSHOP THAT HAS ACCESS TO A HOIST WITH SAFETY EQUIPMENT AVAILABLE.

IMPORTANT NOTE: IT IS THE VEHICLE OWNERS’ RESPONSIBILITY TO CHECK & MAINTAIN THIS KIT AFTER INSTALLATION, EXAMPLE 1-Check all hoses are always securely installed within the fittings in Diffs, Transfer Case, Gear Box or Transmission (ALL BREATHER POINTS) & Bulkhead Breather-Filter fitting within the Mounting Bracket. 2-Check Breather-Filters have not been DAMAGED at all as this will allow Dust, Water & other unwanted contaminates to enter.
IMPORTANT: The warranty does not cover Damage (Breakage) caused by misuse, or improper installation or negligence by the vehicle owner to Check & and; Maintain the installed kit, liability for labor charges or consequential loss or damage of any kind incurred as a result of the failure of a Diesel Manager (DMA) Product / item. IF YOU HAVE A SNORKEL INSTALLED WITH INTENTIONS OF TRAVELING THROUGH WATER CROSSING WHERE THE WATER LEVEL WILL BE OVER THE FRONT BONNET / ENGINE BAY- YOU WILL NEED TO MOUNT THE BRACKET / BREATHER MANIFOLD AT A HIGHER POSITION.

Refund Guarantee Icon
Shop with peace of mind
All marketplace products are covered by our MyDeal Refund Guarantee Learn More
Reference ID: 7639572

Reviews (0) Add Review

No reviews yet