LOCAL & FAST Delivery with warranty on electronics products
Jinni MD portable Sitz Solution Bag 2000cc with kink-resistant tubing. Simple adjustable gravity flow control valve for contact supply of clean solution. No pumping of recycled contaminated solution from the bidet. Illustrated instructions. Fast shipping, Australian owned and based. Used to soothe inflammation and or itchiness for haemorrhoids (piles), anal fissures, rectal surgery, after childbirth, episiotomy, uterine cramps, inflammatory bowel and infections of the bladder, prostate or vagina.
Jinni MD portable Sitz Solution Bag 2000cc with kink-resistant tubing. Simple adjustable gravity flow control valve for contact supply of clean solution. No pumping of recycled contaminated solution from the bidet. Illustrated instructions. Fast shipping, Australian owned and based. Used to soothe inflammation and or itchiness for haemorrhoids (piles), anal fissures, rectal surgery, after childbirth, episiotomy, uterine cramps, inflammatory bowel and infections of the bladder, prostate or vagina.
SITZ BATH 2000cc Solution Bag
For use with the Sitz Bath Superior as a portable bidet. For Maternity, Haemorrhoids and lower body conditions. Gravity flow, no pump required. Adjustable valve controls solution flow.
Soothe lower body inflammation and itchiness from haemorrhoids (piles), anal fissures, childbirth, rectal surgery, episiotomy, uterine cramps, inflammatory bowel and infections of the bladder, prostate or vagina.
Preparing your Sitz Bath:
Raise Toilet lid and seat.
Place Jinni MDTM Sitz Bath basin on the toilet bowl with "front" designation towards the front of the bowl.
Fill Jinni MDTM Sitz Bath with warm water (38 - 40 degrees Celsius or 100 - 105 degrees F) half to two thirds full.
Insert Jinni MDTM Sitz Bath kink resistant tube from the solution bag through to the front or the rear entry hole in the Sitz Bath basin. Snap or secure the Sitz Bath tube into channel in basin bottom.
Bag Preparation:
Position flow control clamp towards Jinni MDTM Sitz Bath Solution bag.
Using clamp, close tubing by sliding clamp over tube from wide to narrow side.
Open top of the bag and fill with hot water (38 - 40 degrees Celsius or 100 - 105 degrees F)
Place or hang bag above Jinni MDTM Sitz Bath.
Using your Sitz Bath:
Sit in Jinni MDTM Sitz Bath for 15-20 minutes.
Use your Jinni MDTM bath as often as recommended by your doctor; generally several times a day as needed to ease discomfort.
To maintain water temperature in the basin, adjust the flow rate from the solution bag by sliding clamp on the tube from narrow to wide side. (Overflow water will drain through the overflow vent openings at the back of the Jinni MDTM Sitz bath basin).
Once the desired temperature is reached, close the clamp by sliding clamp over tube from wide to narrow side.
After treatment, empty and rinse the basin.
Jinni MDTM Sitz Bath Cleaning:
Empty remaining water into the toilet.
Rinse Jinni MDTM Sitz bath with hot water.
Wipe very well and dry it thoroughly.
Replace the solution bag back into a bag to prevent contamination.
WARNING: This product is designed for single patient use only.
Caution: To Avoid burns, temperature of water used SHOULD NOT EXCEED - 43 degrees C (110 degrees F).
